Kerio Tech Firewall6 - Manual (Page 56)

Chapter 6 Internet Connection
56
Figure 6.7 Interface properties — dialing settings
For these purposes, it is possible to set time intervals for persistent connection and/or
hang-up. By clicking on Edit buttons, it is possible to select a time interval for each mode
or create a new interval, without jumping to another, completely different section of the
administration interface.
If the time intervals overlap, the interval in which the link is hung-up rules over the other.
In times outside the defined ranges, the link is dialed on demand.
Note:
1. If a static route over a dial-up is defined in WinRoute’s routing table, this link will
be dialed whenever a packet is routed through there. Settings for the interval within
which the link should be hung-up persistently will be ignored in this case.
For details, see chapter 18.1 .
2. The dialing settings do not include an explicit option of connection recovery upon
failures. In case of connection outage, connection will or will not be recovered in
dependence on the current mode of the link:
• If the link should be connected persistently at the moment of the failure, the