4 front view, 3 hot plugging – Koller-Craft Plastic Hawkeye 1U rack mount 15" TFT monitor/keyboard drawer RPD-1151 User Manual
RPD-1151/1158 User Manual
5.2.4 Front View
1. Port LEDs
On Line:Lights ORANGE to indicate that the computer attached to the
corresponding port is up and running. If the LED is flashing, it indicates that the
Port is being used for Cascading to another Master View switch.
Selected:Lights GREEN to indicate the currently selected port. The LED is
steady under normal conditions, but flashes when its port is accessed under
Auto Scan mode.
2. Port Selection Switches
Press a switch to access the computer attached to the corresponding port
Pressing Buttons 1 and 2 simultaneously for 3 seconds performs a Keyboard
and Mouse reset
Pressing Buttons 7 and 8 simultaneously starts Auto Scan Mode.
5.3 Hot Plugging
The RPD-1158 supports hot plugging - components can be removed and added back
into the installation by unplugging their cables from the platform ports without the
need to shut the unit down. In order for hot plugging to work properly, these
procedures must be followed:
When hot plugging cables from the platform ports, the cable must be plugged back
into the same port it was removed from.