Koller-Craft Plastic Hawkeye 1U rack mount 15" TFT monitor/keyboard drawer RPD-1151 User Manual

Page 38

Advertising
background image

RPD-1151/1158 User Manual

35

Note: 1. If the scanning stops on an empty port, or one where the computer is

attached but is powered Off, the monitor screen will be blank, and the

mouse and keyboard will have no effect. To recover, key in the Hotkey

sequence (see Hotkey Selection, above), for any Port ID that has an

active computer attached.

2. As the OSD cycles through the selected ports, an

S

appears in front

of the Port ID display for each computer to indicate that the computer is

being accessed under Quick View Scan Mode.

F3 List:

This function lets you broaden or narrow the scope of which ports the OSD lists.

The choices and their meanings are given in the table, below:

Choice

Meaning

ALL

To list the Port ID numbers and Names (if names have been

specified - see F5), of all the ports on the installation.

QVIEW

To list only the ports that has been selected for Quick View

scanning (see F4, below).

POWERED ON +

QVIEW

To list only the ports that have been selected for Quick View

scanning (see F4, below), and that have their attached

computers Powered On.

QVIEW + NAME To list only the ports that has been selected for Quick View

scanning (see F4, below), and has been assigned names (see

F5, below).

NAME

To list only the ports that has been assigned names (see F5,

below).

POWERED ON

To list only the ports that have the attached computers powered

on.

To make a choice, move the Highlight Bar to the one you want, then press [Enter].

An icon appears before the choice to indicate that it is the currently selected one.

Note: 1. You can access any port on any list by using the Navigation Keys then

pressing [Enter].

2. If you select a port that does not have a computer attached to it, or if the attached

computer is powered Off, the OSD will still switch to it, and will not show an error.

F4 QV:

QV lets you select the ports you want to include for automatic scanning under the

Quick View Scanning function (see F2, above). [F4] is a toggle: if a port isn 

selected, it selects it; if a port is selected, it deselects.

To select/deselect a port, move the highlight bar to it, then press [F4].

Advertising
This manual is related to the following products: