Connecting a surround processor, Dts disclaimer clause, System connections – Kenwood KRF-V7771D User Manual
Page 11: Connections, Set to 2ch position when not using 6ch input
11
KRF-V7771D (En/T)
System connections
Connections
SYSTEM
CONTROL
FRONT SPEAKERS
(4-16
Ω
)
CENTER
SPEAKER
(4-16
Ω
)
SURROUND SPEAKERS
DIGITAL IN
VIDEO 2
COAXIAL
VIDEO 3
COAXIAL
VIDEO 4
OPTICAL
CD 1
OPTICAL
SL 16 XS 8
( SL 16 )( XS 8 )
(4-16
Ω
)
SWITCHED TOTAL
90W MAX.
L
R
A
L
R
L
C
R
B
SL 16
TEXT
L
R
R
ANTENNA
AM
-
FM 75
Ω
GND
CD1
PHONO
MD/
TAPE 1
REC
OUT
PLAY
IN
REC
OUT
PLAY
IN
PLAY
IN
PLAY
IN
CD2 /
TAPE 2
MONITOR
MONITOR
OUT
FRONT
FRONT
SURROUND
SURROUND
CENTER
CENTER
@
SUB
WOOFER
SUBWOOFER
L
L
R
L
R
VIDEO
S VIDEO
PRE OUT
VIDEO4 6CH. INPUT
AUDIO
VIDEO 3
VIDEO 4
PLAY
IN
VIDEO 2
VIDEO 1
L
R
AUDIO
PLAY
IN
REC
OUT
+
-
6CH
2CH
VIDEO 4
INPUT
6CH
2CH
VIDEO 4
INPUT
FRONT
SURROUND
CENTER SUBWOOFER
VIDEO
VIDEO4 6CH. INPUT
PLAY
IN
VIDEO 4
MONITOR
OUT
S VIDEO
L
R
AUDIO
Connecting a surround processor
DTS Digital Surround
is a descrete 5.1 channel digital audio format available on CD, LD, and DVD software which consequently cannot
be decoded and played back inside most CD, LD, or DVD players. For this reason, when DTS-encoded software is played back through the
analog outputs of the CD, LD, or DVD player, excessive noise will be exhibited. To avoid possible damage to the audio system, proper
precautions should be taken by the consumer if the analog outputs are connected directly to an amplification system. To enjoy DTS Digital
Surround
playback, an external 5.1 channel DTS Digital Surround
decoder system must be connected to the digital output of the CD,
LD, or DVD player.
DTS disclaimer clause
Multi-channel
surround processor
DVD player
The sound input to VIDEO 4 6CH.
INPUT is paired with the video signal
input to VIDEO 4.
Be sure to move the VIDEO 4 INPUT switch to 6CH position
when using the 6CH input.
FRONT
SURROUND
CENTER
SUBWOOFER
VIDEO OUT
÷ Set to 2CH position when not using 6CH input.
Make connections as shown below.
When connecting the related system components, refer
also to the instruction manuals of the related compo-
nents.
Do not plug in the power lead until all connections are
completed.