Kenwood KRF-V7771D - Manual (Page 16)

16
KRF-V7771D (En/T)
Setup
1 Open the cover and remove batteries.
2 Press the reset button with the tip of a thin object for a few
seconds.
÷ This operation clears all of the previously set-up data.
Preparations
÷ Press the POWER key and ON/STANDBY key of the receiver to
turn it ON.
1
1 Remove the cover. ÷ Insert four AA-size (R6/UM-3) batteries as indi-
cated by the polarity marking.
÷ To maintain the memory of the settings you
made before, complete the battery replacement
operation within 30 seconds.
3
2
Perform the following procedure after inserting batteries for
the first time or when the remote control back-up data has
been lost.
4
To reset the remote control
Loading batteries
Setting up the remote control according to your receiver
The “Model Type Setup” screen
appears.
2 Insert batteries. 3 Close the cover.
÷ After selecting an icon, always be sure to press the ENTER key to
enter the selection.
Model Type Setup
Check the display.
Move the cursor to “ Model 2 “.
Enter the selection.
Press the ENTER key.
Setup of the remote control unit
÷ If the remote control backup data is kept stored
when the batteries are replaced, the “Model
Type Setup” menu screen is not displayed. In
this case, operations in
2, 3, 4 are not neces-
sary.
Low battery alarm
When the alarm message
appears to indicate that the
remaining power is low, re-
place all the batteries with
new ones.
3
1
2
2
1
Low
Battery
Model Type Setup
Model 2
Model 1
ENTER
÷ It can be moved in 4 directions, depending on
how you select the icon.
Move the cursor.
Model Type Setup
Model 2
Model 1
ENTER