Kenwood KRF-V7771D - Manual (Page 19)

19
KRF-V7771D (En/T)
Setup
Open the “Setup” menu and select “IR” icon.
Setup for controlling AV components
General setup flow
Assigning the connected components to the selected inputs
2
1 Select the or icon to select an input.
CD1
MD/ Tape 1
CD 2/Tape 2
TV1
TV2
Video1
Video2
Video3
Video4
2 Find out the setup code of the actually connected compo-
nent from the Setup Codes chart and input the code using
icons
1 to ).
3 Select the “Check” icon to test the component.
÷ If the proper code has been entered, the component’s power will
turn on. However, the components which have one of the codes
shown on the left and some components from manufacturers
other than KENWOOD cannot be turned on.
÷ Select “Clr (Clear)” icon to cancel.
4 Select the “Entr (Enter)” icon to register the code.
÷ Icons of the registered components appear on the segment
screen.
Select an input jack name, consult the Setup Codes chart (on the attached sheet) to find out the setup code of the
component connected to the selected input, and enter the 4-digit setup code to assign it to the selected input.
1Open the “Setup” menu and select “IR” icon.
2Assign the connected components to the dis-
played inputs.
3Assign all the connected components.
1
1 Select the “Main Menu” icon.
÷ If the “Setup” menu screen shown on the left has already been
appeared, step 1 can be skipped.
2 Select the “Stp” icon.
3 Select the “IR” icon.
Assign all the connected components.
3
Repeat step 2 for each component connected.
Assign the connected components to the displayed inputs.
The inputs are switched every time
the or icon is selected.
When registering setup codes for KENWOOD audio compo-
nents which are connected to this unit by system control
cords, use the following codes to insure proper system control
operation:
Cassette deck : 7990
Single CD player : 8990
Carrousel CD player : 8991
Multiple CD player (OUTPUT A to CD 1 jacks) : 8992
* 1
Multiple CD player (OUTPUT B to CD2/TAPE2 MONITOR jacks)
: 8993 * 2
MD recorder : 9990
The TV icons that appear on the segment screen after the
setup allow you to use the remote control to control your TV
without connecting it to the receiver as an input.
Lstn Mode Snd Fnc S t p
Tuner CD1
Video2 Video3 Video4 Video1 TV1
Phono
TV2
CD2
MD/
Tape1
CD2/
Tape2 Input
Digital Input
Analog
AV AUX
Macro Remote
Mode
Main
Menu
Snd Lsn Fnc S e t u p
IR
Download
Surround Input
Back Light
Macro
3
1
2
Setup IR
MD/Tape1 MD
#9990 Entr
Clr
Check
1 2 3
4 5 6
7 8 9
0
Input
selector
Component
1
2 3
4
To delete a setup code ¡
*1 This code is only for OUTPUT A operations and for a multiple CD
player which does not have separate outputs such as OUTPUT
A and B.
*2 This code is only for OUTPUT B operations. For a multiple CD
player which does not have separate outputs such as OUTPUT
A and B, use codes on the Setup Code chart.