Kenwood KRF-V7771D - Manual (Page 53)

53
KRF-V7771D (En/T)
Other
Remote control unit
÷ Batteries are exhausted.
÷ The remote control unit is too far away from the
main system, controlling angle is too large, or
there is an obstacle in between.
÷ The audio cords and system control cords are
not connected properly.
÷ The source component to be operated does not
contain the tape(s) or disc.
÷ Batteries are exhausted.
÷ Batteries are removed while something is dis-
played.
÷ Replace with new batteries. ^
÷ Operate the remote control unit within the
controllable range. %
÷ Connect properly referring to “System con-
nection”. 6
÷ Place the tape(s) or disc in the source compo-
nent to be played.
÷ Replace with new batteries. ^
÷ Remove and replace batteries after the infor-
mation display has disappeared. ^
Remote control operation is not possible.
The remote control screen is not displayed.
The remote control display is abnormal.
Remedy Cause Symptom
In case of difficulty
Remedy Cause
÷ No antenna is connected.
÷ The broadcast band is not set properly.
÷ The frequency of the desired station is not
tuned.
÷ Noise due to ignition noise of an automobile.
÷ Noise due to an influence from an electric
appliance.
÷ Noise due to a nearby TV set.
÷ The preset memory was cleared because the
power cord had been unplugged for a long
period of time.
÷ The “Tuner” input is not selected.
÷ Stations are not preset using Auto Memory.
Radio stations cannot be received.
Interference.
A station which was preset cannot be re-
ceived by pressing the corresponding nu-
meric key.
RDS PTY search cannot be carried out.
÷ Connect an antenna. #
÷ Set the broadcast band properly. fl
÷ Tune the frequency of the desired station.
÷ Install the outdoor antenna away from the
road.
÷ Turn off the power to the appliance.
÷ Install the system farther away from the TV
set.
÷ Preset the stations by Auto Memory again.
°
÷ Select the “Tuner” input.
÷ Preset the stations by Auto Memory again.
°
Tuner
Symptom
Note Note
Do not use contact cleaning agents because they could case a malfunction. Be specifically careful against using contact cleaning agents
containing oil, since they may deform the plastic components.