Kenwood KRF-V7771D - Manual (Page 15)

15
KRF-V7771D (En/T)
Setup
Perform “Model Type Setup”
of the remote control before
using it.
^
The following menu display ap-
pears after the batteries are
loaded for the first time.
Controls and indicators
Approximate operating range
1. The supplied batteries are intended for use in operation
check. Therefore, their lives may be shorter than ordinary
batteries.
2. When the remote-controllable distance gets shorter than
before, replace all four batteries with new ones.
3. Malfunction may occur if direct sunlight or the light of a high-
frequency lighting fluorescent lamp enters the remote sen-
sor. In such a case, change the system installation position to
prevent the malfunction.
4. The remote control display may show erroneous information
when the remote control unit is operated from outside the
specified range.
RC : Infrared ray system
Remote sensor
Setup of the remote control unit
Infrared remote
transmitter
ON/STANDBY
MUTE
VOLUME
ENTER
Setup Surround
SP Level
SP Distance
SP Selection
Tuner CD1
Video2 Video3 Video4 Video1 TV1
Phono
TV2
CD2
MD/
Tape1
CD2/
Tape2 Input
Digital Input
Analog
AV AUX
Macro Remote
Mode
Main
Menu
CONFIRM
1
2
3 4 5
6
7
8
9
0
Note Note Note
1Segment screen
The fixed icons are displayed in this area.
÷ Main Menu icon :
Select to display the Main Menu screen. *
÷ Phono icon
÷ CD 1 icon
÷ Tuner icon
÷ MD/Tape 1 icon
÷ CD 2/Tape 2 icon
÷ Video 1 icon
÷ Video 2 icon
÷ Video 3 icon
÷ Video 4 icon
÷ AV AUX icon
÷ TV 1 icon
÷ TV 2 icon
÷ Macro icon : Select to control macro operation. §
÷ Input Digital icon : Select to play a digital input. ª
÷ Input Analog icon : Select to play an analog input. ª
÷ Remote Mode icon : Select to switch the remote control operation
mode without changing the selected input. o
Select to switch input and control the se-
lected input. ( Phono and AV AUX : Input
selection only )
¤ − fi
Select to control TV. fi
2Menu screen
Control key icons and control levels are displayed in this area.
3Communication status display &
Shows the communication status.
4Joy stick &
This key is used to select an icon. This key can be controlled in
4 directions.
5ENTER key &
Press to enter the selection of an icon.
6VOLUME (up, down) key
Press to control the volume.
7CONFIRM key &
Press to confirm the currently selected items.
8MUTE key
Press to mute the audio temporarily.
9 (ON/STANDBY) key
Press to turn the receiver and the components connected to it
through system cords between ON and STANDBY modes.
0Return ( )icon &
Select to return to the previous menu screen.
6m 30º 30º
30º 30º
Notes Notes
Model Type Setup
Model 2
Model 1