Kenwood KRF-V7771D - Manual (Page 39)

39
KRF-V7771D (En/T)
Operations
Preset the selected stations.
2
Select the “Tuner” input and select a station.
Manual memory of broadcast stations
1 Select the “Tuner” icon.
÷ The last tuned frequency is displayed.
2 Select the receiving band.
Select the “Band” icon.
3 Select a station or frequency.
Select the “ ”or “ ” icon.
4 Select the “Memory/10key Pad” icon.
1 Select “Memory” icon.
÷ The memory mode (
Memory ) and preset call mode ( Memory ) are
switched alternately every time the icon is selected.
2 Select one of the preset numbers from 1 to 40.
Select numeric icons as follows...
To preset in “15” .........
05
RDS (Radio Data System)
Apart from the auto memory function, RDS stations can also be stored manually in the preset memory. Other stations than the RDS
stations can also be stored in memory after the Auto Memory of RDS stations.
1
Receiving a manually preset station
÷ If you made a mistake in entering the figure of 10, select the 0
icon repeatedly until the original display is shown, then enter the
correct number.
1. Preset -Call
2. Specifying the preset number
Tuner
RDS Direct
Memory/
10key Pad
FM 108.00MHz
Freq.
11ch
P.Call
Auto Band
÷ Every time the icon is selected, the next station in the order of the
preset number is received.
If the icon is held selected ... Preset stations will be received suc-
cessively for about half a second each.
1 Select the “Memory” icon and switch to preset call mode
( Memory ).
2 Select the preset number (up to 40) of the desired preset
station.
Select numeric icons as follows...
To receive in “20” .......
00)
When “ P.Call ” icons are selected
Select the “ ”or “ ” icon of ”P.Call” to select a preset number.
When “ P.Call ” icons are selected
02 01
......
03 39 40 38
02 01 03 39 40 38
......
÷ Repeat steps 1 and 2 for each of the stations to be stored in
memory.
÷ In the manual memory storage operation of radio stations, it may take
a few seconds after the “Memory” icon is selected till the memory
display starts to blink depending on the receiving condition.
÷ If a station is stored in a preset number which has already stored
a station memory under it, the previous memory is replaced by the
new memory content.
÷ If RDS stations are stored manually in the preset memory, the PS
may not be included in the memory depending on receiving
conditions.
1-ch
Memory/10key Pad
Auto Memory
Memory 1 2 3
4 5 6
7 8 9
0 +10
2
1
Tuner
RDS Direct
Memory/
10key Pad
FM 108.00MHz
Freq.
11ch
P.Call
Auto Band
Tuner CD1
Video2 Video3 Video4 Video1 TV1
Phono
TV2
CD2
MD/
Tape1
CD2/
Tape2 Input
Digital Input
Analog
AV AUX
Macro Remote
Mode
Main
Menu
1
2
3
4
Memory/10key Pad
Auto Memory
Memory 1 2 3
4 5 6
7 8 9
0 +10
11ch
2
1