Kathrein UFS 790sw - Manual (Page 16)

16
FIRST INSTALLATION: Single-cable system (general)
The various options
for a single-cable
system with Kathrein
components are
summarised at
the end of this manual in the
“Technical Appendix” section
under “Examples of Single-Cable
Systems”.
Depending on the system to which
they are connected, a maximum
of four or eight receivers may
be connected to a single-cable
system (a twin receiver counts
as two receivers)
Use the

buttons here to select the satellites you want to receive with your system. Press the
!
(green) button to open the next menu:
Note: You can only receive the signals from two satellites in your single-cable system if
a EXU 908 single cable matrix is used. In this case, repeat the “Satellite selection”
process for the “Position B” line.
Satellite selection
Press the button. The following display appears:
Use the

buttons here to select “One Cable” as “LNB control”. Press the

button to move to the
next menu item:
If the receiver is
connected to an
UAS 481 single-cable
LNB, it is imperative
the two frequencies
(low band/high band) are set to
10200 MHz here.
You can make the settings using
either the number pad or the

buttons.