Kathrein UFS 790sw - Manual (Page 20)

20
Testing connection:
Use the

button to switch to the “Test connection” line and press the button. The receiver now tests
the settings you have made. The following message appears:
Press the button to confi rm.
Press (if necessary several times) the
!
(green)
button until you reach the “Channel list selection”
point.
Continue the fi rst installation with the “Search”
section.
Press the button to confi rm and check your
settings. If necessary, seek assistance from a
specialist engineer.
Use the

button to switch to the “Test
connection” line again and press the button.
As soon as the receiver outputs the “Connection
OK” message, you can continue as described
on the left.
FIRST INSTALLATION: Single-cable system (Manual)
Transmission frequency (only with the selection “User defi ned”):
Use the

button to switch to the “Transmission frequency” line and enter the appropriate
transmission frequency using the number pad. You can fi nd the necessary information (transmission
frequencies) in the documentation supplied with your system.
Secure channel with PIN:
Press the

button to switch to the “Secure channel with PIN” line. Here it is possible to protect the
transmission frequency used by entering a PIN. No other receiver can then use that transmission
frequency unless the PIN is input. Select the setting “Yes” using the

buttons.
Password PIN (only for “Yes” setting in the “Secure channel with PIN” line):
Select the “Password PIN” line using the

button. You can now use the number pad to enter
a PIN (0-255).
You can only use the “Secure channel with PIN” function if this function is
supported by the single-cable components used. In the case of Kathrein
single-cable components, this is currently only the case for the EXU 908.