Kathrein UFS 790sw - Manual (Page 19)

19
MANUAL
Connected equipment:
Select the single-cable components used in your system using the

buttons. Available options:
Kathrein 2 subscribers (EXR 552), Kathrein 4 subscribers (EXR 501, EXR 551), Kathrein 8 subscribers
(EXR 1581, EXR 2581, EXU 908) or User defi ned (UAS 481).
We have selected the UAS 481 single-cable LNB as an example for the remainder of this
explanation. If there are differences to other components or to the setting “User defi ned”, we will
note and explain these differences.
Transmission channel:
Press the

button to switch to the “Transmission channel” line. Select the required transmission
channel using the

buttons.
If one or more receivers are already present on the system and an additional
receiver is to be connected, you must assign a different frequency (transmission
channel) to the new receiver (otherwise the receivers will interfere with each other).
FIRST INSTALLATION: Single-cable system (Manual)
Press the button to confi rm.
Press (if necessary several times) the
!
(green)
button until you reach the “Channel list selection”
point.
Continue the fi rst installation with the “Search”
section.
Press the button to confi rm and check your
settings. If necessary, seek assistance from a
specialist engineer.
Use the

button to switch to the “Test
connection” line again and press the button.
As soon as the receiver outputs the “Connection
OK” message, you can continue as described
on the left.