Kathrein UFS 790sw - Manual (Page 2)

2
FOREWORD/IMPORTANT INFORMATION
Dear customer,
This operating manual is intended to help you make the fullest use of the extensive range of functions offered
by your new satellite receiver.
We have tried to make the operating instructions as easy as possible to understand, and to keep them as
concise as possible.
If you will not be using your receiver for a longer period, you should disconnect it from the mains to save
energy. For shorter breaks, you can use the remote control to switch the receiver to standby, which uses only
a minimal amount of energy.
We wish you good reception and much pleasure using your new DVB-Sat receiver.
Your
KATHREIN team
The programs available on the satellites and transponders as well as the DVB-T channels are subject to
continual change. This means the channel settings have to be regularly updated, even though the factory
presetting always represents the latest version when the receiver was shipped. The information for these
settings can be found on the Internet or in relevant magazines.
Your receiver was equipped in the factory with the latest software version at that time. We are, however,
constantly working on adapting the software to the wishes of our customers and to developments in
technology. The “Software Update” section provides more information on this aspect.
The information in this operating manual was correct at the time of going to press.
We reserve the right however to make changes at any time and without prior notice.
If new software is released for your receiver, and this affects the information in the operating manual
(e.g. changes to the menus and/or functions), if we believe it necessary we will make available a new
operating manual for download under “www.kathrein.de”.
Please keep the original packaging in case you need to return the product at any time!
If the product is not properly packed, the warranty claim is invalidated.
Make a note of the receiver's basic settings (these are set during the fi rst installation), so you can restore
them if necessary!
The term DiSEqC™ used in this operating manual is a registered trade mark of the European
Telecommunication Satellite Organisation (EUTELSAT).
In order to disconnect the UFS 790 from the mains completely, the mains plug must
be unplugged from the wall socket! Therefore place the UFS 790 near to a wall
socket and make sure the socket is accessible, so that at any time (e.g. during a
thunderstorm or during a long absence) you can disconnect the receiver from the
mains.
IMPORTANT INFORMATION