Kathrein UFS 790sw - Manual (Page 56)

56
SECURITY
Press the

button to open the main menu. Select the “Security” menu using the

buttons
and press the button. Enter the receiver PIN (factory setting “0000”) and confi rm it by pressing
the button. The following display appears (see example below):
Use the

buttons to select the lines to be changed and use the

buttons to perform the
settings.
Receiver Lock:
If the receiver lock is set to “On”, when the receiver is switched on it will request input of the PIN.
Menu Lock:
If the menu lock is set to “On”, the PIN must be entered as soon as the main menu is opened.
Channel Lock:
If the channel lock is set to “On”, the PIN must be entered as soon as a channel is opened that
has been marked as locked in “Edit Channel List”.
Change Device-PIN:
Press the button, you will be requested to enter the old PIN. Confi rm the entry of the old PIN using the
button. Now enter the new PIN and confi rm by pressing the button. Then you must enter the new
PIN again and also confi rm using the button. “The receiver PIN has now been changed” is displayed.
Press the button to close the message.