Lexmark 5400 Series - Manual (Page 71)

3 When reading of images is complete, the number of photos found appears on the display.
Notes:
• If the printer does not read the memory card, remove and reinsert it. For more information, see “Memory card
reader and PictBridge troubleshooting” on page 137.
• The printer recognizes one active media device at a time. If you insert more than one media device, a message
appears on the display prompting you to designate the device you want the printer to recognize.
Related topics:
• “Inserting a flash drive” on page 71
• “Using the control panel” on page 90
Inserting a flash drive
1 Insert the flash drive into the PictBridge port on the front of the printer.
Note: An adapter may be necessary if your drive does not fit directly into the port.
2 If your flash drive has a light, it blinks to indicate the flash drive is being read or is transmitting data. Wait for the
light to stop blinking.
Warning—Potential Damage: Do not remove cables or media devices, or touch the printer in the area shown
while the light is blinking.
3 When reading of images is complete, the number of photos found appears on the display.
Note: The printer recognizes one active media device at a time. If you insert more than one media device, a message
appears on the display prompting you to designate the device you want the printer to recognize.
Related topics:
• “Inserting a memory card” on page 70
• “Using the control panel” on page 90
Working with photos
71