Printronix L5520 - Manual (Page 43)

Factory Settings
43
Factory Settings
The configuration defaults set at the factory are listed below. These
values are available for loading at any time, and are maintained in
the printer until a new configuration is loaded.
Table 1. Factory and Configuration Parameters
Menu Item Default Value
Config. Control
Load Configuration 0
Save Configuration 1
Print Configuration Current
Delete Configuration 1
Power-up Configuration 0
Protect Saved Configuration Disable
Name Configs
Reset Cfg Names
Mode LinePrinter+
Host Interface
Centronics
Data Bit 8 Enable
PI Ignored Enable
Data Polarity Standard
Resp. Polarity Standard
Busy On Strobe Enable
Latch Data On Leading
Prime Signal Enable