Printronix L5520 - Manual (Page 90)

Chapter 3 Miscellaneous Menu
90
Subsequent printing observes the current setting for skip-over
perforation, form length, and top-of-form position parameters.
If a fault occurs while printing a hex dump, the printer reverts to the
normal fault state. When the fault is cleared, the printer resumes
printing the hex dump (either a partial line with a form feed or
nothing at all). Top-of-form remains unaffected.
Figure 4. Sample Hex Dump
To begin a hex dump, place the printer offline and enable the Hex
Dump Mode option from the control panel. Next, place the printer
online. Finally, send data to the printer from the host computer. Any
data received from the host is “dumped” to the printout.
To cancel a hex dump, place the printer offline. Then, disable the
Hex Dump Mode option from the control panel. The paper may then
be advanced to the next top-of-form.
PTX SETUP Option
The PTX SETUP Option menu selection has two submenu
selections: Setup Parse and Setup SFCC. Only appears with IGP
and LP+, not PCL5.
Setup Parse
Setup Parse allows you to enable or disable PTX SETUP
processing. If Setup Parse is disabled, the printer prints PTX
SETUP commands as regular text. The default setting is Disabled.
Setup SFCC
Setup SFCC sets the Special Function Control Code (SFCC) for
the PTX SETUP functions. The default setting is decimal 33.