Printronix L5520 - Manual (Page 75)

IEEE 1284 Parallel Parameters
75
IEEE 1284 Parallel Parameters
The IEEE 1284 interface is faster and more versatile than that of
the Centronics interface and supports bidirectional communication.
Configuration of this interface is controlled from the host.
Prime Signal
• Enable. This parallel port will perform a warm start (reboot)
when the host asserts the Prime Signal.
• Disable. This parallel port will not perform a warm start (reboot)
when the host asserts the Prime Signal.
TOF Action
• Reset. A form feed is done before a warm start when the Prime
Signal is asserted from the host. This setting is used only if the
Prime Signal parameter is enabled.
• Do Nothing. Nothing occurs before a warm start when the
prime signal is asserted from the host.
Buffer Size In K
This option configures the amount of memory allocated for the
IEEE 1284 parallel port buffer. You can specify between 1 and 128
Kbytes.
* Factory Default.
1
If installed.
Ethernet 1 Serial Centronics
HOST
INTERFACE
IEEE
1284 Auto
Switching
Dataproducts
Buffer Size
In K
TOF
Action
Prime
Signal
Enable*
Disable Reset*
Do Nothing 1
4
8
32
128 2
6
16
64*