Printronix L5520 - Manual (Page 84)

Chapter 3 Paper Control Menu
84
Fanfold Options
Image Width
Image Width specifies the width of the image to be printed. The
allowable range is 2.0 to 14.7 inches, in 0.1 inch increments. The
factory default is 14.6 inches.
Form Length
Form Length is the logical form length for fanfold paper. You can
specify the form length in either of two ways: in inches or in the
number of print lines (at six lines per inch).
• Inch Select/Length in Inches (the default). This selection allows
you to set the form length in inches. The range is from 1.0 to
30.0 inches, in one-half inch increments. The default is 11.0
inches.
• 6 LPI Select/Length at 6LPI. This selection allows you to set the
form length in lines. The range is from 6 to 180, in one line
increments. The default is 66 lines.
Paper Length
Paper Length is the physical form length for fanfold paper (the
vertical perforation to perforation distance). You can specify the
paper length in three ways: Auto Select, inches, or the number of
print lines (at six lines per inch).
• Auto Select (the default). Using Auto Select, the printer uses
the current setting of the “Form Length” parameter to find the
best physical paper length within the valid range, and then use
that value. If the form length parameter setting is within the
valid range for the paper length parameter, the printer uses the
value for both the form length and paper length parameters. If
the form length parameter is outside the valid range for the
paper length parameter, the printer finds a multiple or divisor of
the form length parameter closest to 11 inches.