Panasonic AJ-HD1800P - Manual (Page 40)

40
Function menus
(continued)
<HOME>
The most basic settings for recording, playback and TC
operations are set on this menu screen.
How to switch the settings
Toggle:
Each time a function button is pressed, the setting is
changed or entered.
F i toggle*:
When a function button is pressed while the F button is
held down, the setting can be changed or entered each
time.
Toggle i ADJ:
When a function button is pressed, the setting is
highlighted, and the status in which the setting can be
changed is established.
The ADJUST dial is used to change the setting.
When the same function button is pressed again and the
highlighting is released, the setting is entered.
Press:
When a function button is pressed, the setting can be
changed while the button is held down or at the instant
when it is pressed. When the function button is released,
the original setting is restored.
F i press*:
When a function button is pressed while the F button is
held down, the setting can be changed while the button is
held down or at the instant when it is pressed. When the
function button is released, the original setting is restored.
* When only the function button is pressed, message
display “Press + ” etc. blinks.
Function button
to :
These buttons control the functions displayed in the
Function Menu.
<Note>
Changes in the settings made with the function buttons
that control the Setup Menu are reflected in the system
immediately, but about 5 seconds is required to store the
settings. To turn off the power after changing the settings,
wait about 5 seconds or more and then turn off the power.
:
This button shifts the display alternately between the
current function menu and the back page menu.
Back Page Menu Indicator
;: This is displayed when the front page menu is
displayed.
::
This is displayed when the back page menu is
displayed.
Function button operation inhibited indicator
This is displayed when the button is pressed while the
button is held down. When it appears, the operation of
the function buttons can be inhibited. When the button is
pressed again while the button is held down, the display
is cleared, and it becomes possible to operate the function
buttons.
Warning symbol
When a warning occurs on the unit, the warning symbol (W)
blinks. (For details, refer to the Function Menu <DIAG> on
page 57.)
F1 SHIFT F2 F3 F4 F5 F6
Warning mark
Name of menu displayed
Status display 2
Remaining tape/total tape
Operation mode/speed
Time counter
Cue time
Status display 1
Status display3
Back page
menu
indicator
F1 SHIFT F2 F3 F4 F5 F6
F F5
F1 F6
SHIFT
BS
F
F