Setup menus, Continued) – Panasonic AJ-HD1800P User Manual
Page 85
85
Setup menus
(continued)
<BASIC> (continued)
*1:
When the 50 Hz mode, 25 Hz (HD, SD) mode, or 50 Hz (HD,
SD) mode is selected in System Menu No. 25 (SYSTEM
FREQ), this item is not displayed.
*2:
When the 23/24 Hz mode is selected in System Menu No. 25
(SYSTEM FREQ), this item is not displayed.
*The underlining (__) denotes the factory setting mode.
No./Item
Description of setting
022
PB FORMAT
For selecting the format in which the tape is to
be played back.
0000
MANU
The format is determined by the setting selected
for setup menu item No.023 (FORMAT SEL).
0001
AUTO1
The unit follows the format recorded on the tape.
Whenever the format is changed during
playback, the playback format switches to others
according to the changed format.
0001
AUTO2
If the playback format does not change for 1
second or more after the SERVO lamp lights
when starting playback, the current playback
format is fixed. The fixed playback format is
retained as is even if the format recorded on the
tape is changed unless the playback mode is
released.
023
FORMAT
SEL
For selecting the format when “MANUAL” has
been selected as the setup menu item No.022
(PB FORMAT) setting.
If “AUTO” is selected as the setting, the format
when playback starts is selected, and when the
tape is played back, the format is automatically
detected and matched with the format of the
playback tape.
0000
HD-LP
The DVCPRO HD-LP format is selected, and the
setup menu item No.020 (SYS FORMAT) setting
is followed.
0001
HD-SP
The DVCPRO HD format is selected, and the
setup menu item No.020 (SYS FORMAT) setting
is followed.
0002
422
The DVCPRO50 (422) format is selected.
0003
411
The DVCPRO (411) format is selected.
0005
DV
The DV format is selected.
0006
DVCAM
The DVCAM format is selected.
030*
1
HD
FREQUENCY
For setting the field system frequency
0000
59/23
The 59.94/23.98 Hz frequency is set.
0001
60/24
The 60/24 Hz frequency is set.
<Notes>
z The set field frequency is enabled only when
there is no input for the OUT REF settings. If
there are any corresponding inputs, the field
frequency coincides with the field frequency of
the input.
z When the HD SDI output is output with 60 Hz/24
Hz, the SD SDI is output as NO SYNC, and the
analog composite is output in the White/Black
mode (burst off).
No./Item
Description of setting
031*
2
OUT REF
Video output reference
0000
AUTO
When the HD REF input signal is supplied, it is
used as the reference. If it is not supplied but the
SD REF input signal is supplied, the SD REF
signal serves as the reference instead.
If neither the HD REF nor SD REF input signal is
supplied, the HD serial signal serves as the
reference.
If none of the HD REF, SD REF and HD serial
signals are supplied, the internal sync signal
serves as the reference.
0001
INPUT
When the serial input signal is supplied, it is used
as the reference
.
0002 HD_REF
The signal which is input to the HD REF IN
connector is used as the reference.
0003 SD_REF
The signal which is input to the SD REF IN
connector is used as the reference.
0004 E-AUTO
In edit mode, the state is the same as set in
[INPUT]. In modes other than edit mode, the
state is the same as set in [AUTO].
<Note>
For details, refer to [