Printronix P3000 Series - Manual (Page 133)

6–47 Programming
Line Spacing 1/6 Inch
ASCII Hex Decimal
P–Series SFCC LPI;n
SFCC 2
SFCC 32 SFCC 50
Serial ESC 2 1B 32 27 50
Purpose Sets line spacing to 6 lpi or as set by ESC A.
Comment The value of n can only be 6 or 8. In P–Series protocol and LPI mode, if n = 6, this
command sets line spacing to 1/6 inch. Values of n other than 6 or 8 cause an error
message (Command Line Error Messages are listed on page 6–3).
SFCC/ESC 2 asserts n/72–inch line spacing as set by SFCC/ESC A (page 6–51). If
no distance has been set by SFCC/ESC A, the distance is 1/6 inch.
The control code line spacing selection overrides the control panel line spacing set-
ting.
Example The following example illustrates 1/6–inch line spacing and assumes that a distance
has not been set by ESC A.