Printronix P3000 Series - Manual (Page 38)

Configuration 3–2
From the main configuration menus below, related configuration parameter values can be displayed
and selected.
•
Character Set
•
Application Compatibility
•
Paper Format
•
Host Interface
•
Load Parameters
•
Save Parameters
•
Diagnostics
Once the ENTER switch is unlocked, displayed values can be selected as the current configuration by
displaying the value in the message display and pressing ENTER. You can exit from a configuration
menu by pressing CLEAR, which places the printer off line.
NOTE: If an “E” is displayed in the upper right corner of the LCD, the VFU is enabled. If a
“L” is displayed in the lower right corner of the LCD, the VFU is loaded.
Configuration Printout
The configuration printout lists all of the currently selected configuration parameter values. A sample
configuration printout is shown in Figure 3–1. Configuration parameters on the printout are listed in
the same order as the configuration menu via control panel.
The following general procedure is used to obtain a configuration printout. Refer to the Control Panel
Configuration Diagram beginning on page 3–7 for an illustration of the available menus and values.
When you return to OFFLINE READY, the previous print mode and LPI is restored, and all print at-
tributes are canceled. All other format parameters are unaffected.
1. Place the printer off line.
2. Select and display the CONFIGURATION PRINTOUT menu in the DIAGNOSTICS menu by
pressing MENU DOWN and then PREV VALUE until DIAGNOSTICS appears in the message
area.
3. Press MENU DOWN to display CONFIGURATION PRINTOUT in the message area.
4. Press R/S. The configuration printout prints.
5. Press CLEAR to return to OFFLINE READY.
6. Place the printer on line.