Skip–over perforation – Printronix P3000 Series User Manual
Page 148
Programming
6–62
Skip–Over Perforation
ASCII
Hex
Decimal
P–Series
N/A
N/A
N/A
Serial
ESC N n
1B 4E n
27 78 n
Purpose
Selects the number of lines (at the current line spacing) for the paper “skip” at the
bottom of the perforated page.
where
n = 1 to 127 to select the number of lines to skip. If the value of n exceeds the
current forms length, it is ignored.
Comment
The actual distance set is the product of n and the current line spacing. The factory
default value is to disable skip–over perforation. You can specify the default value.
Setting a new forms length (ESC C) resets skip–over perforation to zero.
This feature is disabled whenever vertical tabs are set.
You can also select skip–over perforation from the control panel; however, vertical
tabs within the skip–over perforation zone, as set by the control panel, are ignored.
The control code skip–over perforation setting from the host computer overrides the
control panel setting.