Login and logout, Operator registration – Panasonic WJ-SX650 User Manual

Page 55

Advertising

LOGIN AND LOGOUT

■ Operator Registration

Before logging into the system, operator registration is required. Operator registration is performed in "Operator" – "Operator" of
WJ-SX650 Series Administrator Console. The factory default of operator information is as follows.

• Operator No.: Number given for operator registration.

Up to 59 operators can be registered.

• User ID: ID number of operator controlling this unit. 1 to

99998 are available.
Note: Begin the entry with a numeric other than "0".

• Password: For login, a password is checked as well as

a User ID. Up to 5 digits are available.
Note: To protect system controllers from misuse, be

sure to change the factory default passwords.

• Level: An operator's restrict level. 1 to 5 are available. 1

is the highest, and 5 is the lowest.
Note: Desired functions can be assigned to each level

in "Operator" – "Level Table" of WJ-SX650 Series
Administrator Console.

• Priority: Operator priority given to control a monitor,

camera, or recorder selected by another operator. 1 to
99 are available. 1 is the highest, and 99 is the lowest.

• Camera Access: View and control can be enabled or

disabled for each camera.
VIEW & OPERATE: An operator can display the select-

ed camera image on the selected monitor. The
operator can also control the camera.

VIEW: An operator can display the selected camera

image on the selected monitor, but cannot control
the camera.

- -: The operator can neither display the selected cam-

era image on the selected monitor nor control the
camera.

• Recorder Access: View and control can be enabled or

disabled for each recorder.
VIEW & OPERATE: An operator can display the select-

ed recorder image on the selected monitor. The
operator can also control the recorder.

VIEW: An operator can display the selected recorder

image on the selected monitor, but cannot control
the recorder.

- -: The operator can neither display the selected

recorder image on the selected monitor nor control
the recorder.

• Monitor Access: Control can be enabled or disabled

for each monitor.
Notes:

• Monitor Access is set for each DATA port.

Operators logging into the system from the same
DATA port have the common setting.

• Monitor Access setting is not applied for operators

logging into the system from the PC connected to
the SERIAL port.

• Monitor Access setting is performed in "Controller" –

"Monitor Access" of WJ-SX650 Series Administrator
Console.

Operator No.

650

View & Operate
(All cameras)