Panasonic WR-DA7 - Manual (Page 142)

[EXPANDER] mode
[THL] Area
Threshold sets the level at which the expander begins to make the signal
louder by the pre-determined ratio. Signals below the threshold point will
not be affected by the expander. Signals above the threshold point will be
raised in volume by the ratio set. Values for the threshold are -80 dB to -15
dB.
[RATIO] Area
The ratio parameter sets the amount of expansion (amount of output signal
change compared to the amount of input signal change). Values for ratio are
from 1:1 to
∞
:1.
[ATTACK] Area
The attack time is how long it takes for the expander to kick in after the
signal has triggered it. Values for attack time are from 0 ms to 250 ms.
[RELEASE] Area
Values for release time are from 5 ms to 2 000 ms.
[RANGE] Area
This parameter is only available in the expander mode. The gate parameter is
usually on or off. However, you can set a range so the gate does not
completely close and dynamically adjust the signal level coming through the
gate. Values for range are from 0 dB to 40 dB.
DELAY Button
This button switches the delay or .
[DELAY] Area Controls
The channel delay is inserted after the EQ and dynamics and
before the fader in the audio path, thus delaying a signal. This
function could be useful for fixing timing differences on different
sources or intentionally off-setting the time of a track to create an
effect.
Adjust the delay value from 0 msec / 0 sample to 300 msec / 14400
sample.
DLY value [msec] = sample value divided by the number
left by removing kHz from a sampling frequency. Example: When
the sample value is 7200 and the sampling frequency is 48 kHz, the
DLY value = 7200 divided by 48 = 150 msec.
OFF ON
OFF
C h a p t e r 9
D A 7 U s e r s ’ G u i d e 9 - 1 0
9
Dynamics/
Delay