Panasonic WR-DA7 - Manual (Page 240)

This selection determines whether the motorized faders are active or
not. When this selection is off, automation will still play back and on
the
TopPanel a LED button in the FADER LAYER Selection
section will blink if selected.
This selection determines whether the TALK BACK button on the
Top Panel is set to a momentary or locked position. In momentary,
the button only operates when it is continually pressed. In locked
mode, once pressed, the
TALK BACK button will stay on until
pressed again.
This button makes the DA7 match the polarity of the remote
switch connected to DA7's Rear Panel. Cursor to this button, and
press the
ENTER button to activate, if a Closed type switch is
normally used. The default setting to the button is inactive and
matches a normally Open type switch.
When this selection is on, if the sync of the master wordclock
becomes unlocked, a warning message is displayed.
When this selection is on, pressing Keypad numbers sends a MIDI
program change message and recalls a scene memory from 00-50
corresponding to the numbers entered.
When this selection is on, a confirmation message is displayed when
a library or scene memory is saved via the
button.
If this selection is on, a confirmation message is displayed when a
library, scene memory, or automation data is recalled.
This selection is unassigned and is for future use and applications.
C h a p t e r 1 6
D A 7 U s e r s ’ G u i d e 16 - 1 0
16
Utility