Panasonic HD1700pe - Manual (Page 113)

113
Display position
The position of the characters superimposed on the
display can be changed using
(C HPOS) and
(C VPOS) on the <TC SHIFT> menu and the ADJ
dial.
F3 F2
Superimpose screen
The control signals, time code, etc. are displayed on
this screen using abbreviations.
TCR 22 : 22 : 22 : 22
TV monitor
TCR 22 : 22 : 22 : 22
TV monitor
TCR 22 : 22 : 22 : 22
TV monitor
Abbreviations
CTL: Control signal count value
TCR: Time code data recorded in the SBC area
TCR.: Time code data recorded in the VAUX area
UBR: User’s bit data recorded in the SBC area
UBR.: User’s bit data recorded in the VAUX area
TCG: Time code data of the time code generator
UBG: User’s bit data of the time code generator
Operation mode
The VTR’s operation mode can also be displayed
using
(DISPLY) on the <TC SHIFT> menu. F4
TCR 22 : 22 : 22 : 22
STOP
TV monitor
VTR operation mode
Characters displayed
The background of the characters superimposed on
the display screen can be changed using
(C
TYPE) on the <TC SHIFT> menu.
F5
TCR 22 : 22 : 22 : 22
TV monitor
T TC CR R 2 2 2 2 :: 2 2 2 2 :: 2 2 2 2 :: 2 2 2 2
TV monitor
<Note>
When the 23/24 Hz mode has been selected as the
system menu item No.25 (SYSTEM FREQ) setting,
the time code and other information superimposed on
the MONITOR and VIDEO OUT3 connectors are not
displayed.
<Note>
[T2R], [T2R.], [U2R] or [U2R.] is displayed when the
data has not been read correctly from the tape.