Panasonic HD1700pe - Manual (Page 46)

46
Function menus
<HOME>
Function
button/item
Switching
method
Corresponding setup
menu item
F1
OUTPUT Toggle No. 140
OUTPUT
Description of setting
For selecting the output signals.
<In the STOP mode>
TAPE: In the STOP mode, the signals played back from the
tape are output.
During recording or editing (*), simultaneous playback
signals are output.
*: Setup menu item No.302 (CONFI EDIT) must be set.
EE: The input signals selected by the setup menu items
No.600 (VIDEO IN SEL) and No.713 (CH1 IN SEL) to
No.724 (D IN SEL 78) settings are output.
Setting
TAPE
EE
F3
TC/CTL*
2
Toggle ___ For selecting the time counter display.
TC: The time code value is displayed.
UB: The user’s bit value is displayed.
CTL: The control signal (time data) is displayed.
TC
UB
CTL
F6
R INH F i toggle No. 113
REC INH
Refer to the setup menu.
<Note>
The setting can be changed from OFF to ALL simply by
operating the function button without pressing the F button. OFF
ALL
PRE
NORM
V/CTL
F4 (SHIFT)
CAPSTN F i toggle No. 109
CAP. LOCK
Refer to the setup menu. 2F
4F
8F
F3 (SHIFT)
OUTREF F i toggle No. 031
OUT REF
Refer to the setup menu. AUTO
INPUT
HD_REF
SD_REF
F1 (SHIFT)
PREROL Toggle i
ADJ
No. 000
P-ROLL TIME
Refer to the setup menu. 0s --- 5s ---
30s
F6 (SHIFT)
VARMEM*
1
Toggle ___ For selecting the variable memory mode.
OFF: The variable memory mode is not used.
ON: The status is established in which variable memory
playback or variable memory editing is enabled.
OFF
ON
F4
TC CLR*
1
Press ___ For resetting the time counter display.
If the F4 button is pressed while the control signal (time
data) is displayed on the time counter, it is reset to zero. RESET
F2
___ ___ ___ ___ ___
F5
___ ___ ___ ___ ___
F2 (SHIFT)
___ ___ ___ ___ ___
F5 (SHIFT)
___ ___ ___ ___ ___
*The underlining (__) denotes the factory setting mode.
*1: This item is not displayed when the 23/24 Hz or 25 Hz (HD or SD) mode has been selected as the system menu item No.25 (SYSTEM
FREQ) setting.
*2: CTL cannot be selected when the 23/24 Hz or 25 Hz (HD or SD) mode has been selected as the system menu item No.25 (SYSTEM
FREQ) setting. TC is selected when the power is turned on.