Connector signals, Printed circuit boards, Caution – Panasonic HD1700pe User Manual

Page 129: Parallel remote (50p), Encoder remote(15p), Rs-232c, F1 board (adda), H3 board (cue)

Advertising
background image

CUE INPUT IMPEDANCE SW
This sets the CUE input impedance.

HIGH/600

129

Connector signals

PARALLEL REMOTE (50P)

Refer to 50P IN/OUT ASSIGN on the function menu
(page 75) for the connection pin signals.

ENCODER REMOTE(15P)

Pin No.

Signal

1

FRAME GROUND

4

REM (G)

7

REM RX (X)
REMOTE CONTROL PROTOCOL RECEIVE

8

REM TX (X)
REMOTE CONTROL PROTOCOL TRANSMIT

14

REM RX (Y)
REMOTE CONTROL PROTOCOL RECEIVE

15

REM TX (Y)
REMOTE CONTROL PROTOCOL TRANSMIT

RS-232C

(D-SUB 25-pin, crossover cable supported)

Pin No.

Signal

Description

1

FG

Protective ground (frame ground)

2

RXD

Received data (data is sent to PC)

3

TXD

Transmitted data (data is received
from PC)

4

CTS

Clear to send (shorted with pin 5)

5

RTS

Request to send (shorted with pin 4)

6

DTR

Data terminal ready (no processing)

7

SG

Signal ground

20

DSR

Data set ready (+ voltage output after
communication enable status)

Printed circuit boards

F1 board (ADDA)

Switch No.

What is set

SW1

SW101

AUDIO INPUT IMPEDANCE SW
This sets the CH2 audio input impedance.

HIGH/600

SW201

AUDIO INPUT IMPEDANCE SW
This sets the CH3 audio input impedance.

HIGH/600

SW301

AUDIO INPUT IMPEDANCE SW
This sets the CH4 audio input impedance.

HIGH/600

The underlining (__) denotes the factory setting mode.

AUDIO INPUT IMPEDANCE SW
This sets the CH1 audio input impedance.

HIGH/600

H3 board (CUE)

Switch No.

What is set

SW101

CAUTION:

These servicing instructions are for use by
qualified service personnel only. To reduce the
risk of fire or electric shock do not perform any
servicing other than that contained in the
operating instructions unless you are qualified
to do so.

Advertising