Paradyne 7612 SNMP DSU - Manual (Page 103)

MIB Descriptions
C-17 7612-A2-GB20-10 November 1997
Output Signal Table Objects
The Output Signal Table contains entries for the output signals that can be
asserted by the unit, for the synchronous User Data port. Clarification for objects
contained in this table as it applies to the unit is provided in
Table C-12 .
Table C-12. Output Signal Table Objects
Object Description Setting/Contents
rs232OutSigName
(rs232OutSigEntry 2 ) Contains the identification
of a hardware output signal. Supports only the following
values:
cts(2) – Clear To Send
dsr(3) – Data Set Ready
dcd(6) – Received Line Signal
Detector
rs232OutSigState
(rs232OutSigEntry 3 ) Contains the current signal
state. Supports only the following
values:
on(2) – The signal is asserted
off(3) – The signal is deasserted
rs232OutSigChanges
(rs232OutSigEntry 4 ) Indicates the number of
times that a signal has
changed from on to off, or
off to on. Increments the object each time
that the signal is sampled (every
100 ms) and the signal state is
different from the previous state.
Ethernet-Like MIB, RFC 1643
The unit supports the Ethernet-Like MIB, RFC 1643 for all objects except :
H dot3TestTdr, and
H
dot3StatsEtherChipSet
Enterprise MIB
The following Paradyne Enterprise MIB Objects are supported by the unit:
H
Device Configuration Variable (pdn-dev Config 7)
H Port Usage Table, pdn-devPortUsage (pdn-interfaces 3)
H
DDS Interface Specific Definitions, pdn-dds (pdn-interfaces 2)
H
Device Security, pdn-security (pdn-common 8)
H Device Traps, pdn-traps pdn-common 9)
H Device Control, pdn-control (pdn-common 10)