Paradyne 7612 SNMP DSU - Manual (Page 90)

MIB Descriptions
C-4 7612-A2-GB20-10 November 1997
Table C-2. Interfaces Group Objects (2 of 4)
Object Setting/Contents Description
ifType
( ifEntry 3 ) Identifies the interface
type based on the
physical/link
protocol(s), right below
the network layer. Supported values:
H ethernetCsmacd(6) – Used for the
Ethernet port.
H other( 1 ) – Used for the DDS network.
H ppp( 23 ) – Used for the In-band
Management Channel.
H rs232( 33 ) – Used for the Terminal port.
H v35( 45 ) – Used for the User Data port.
ifMtu
( ifEntry 4 ) Identifies the largest
datagram that can be
sent or received on an
interface (Ethernet port
or IMC). Number of octets.
ifSpeed
( ifEntry 5 ) Provides the current
bandwidth for the
interface in bits per
second. H Ethernet Port – The data rate for the port.
H Terminal port – Configured data rate for
the port.
H DDS – Line rate of 56,000 or 64,000 bps,
reflecting the line rate detected by the unit.
H User data (DTE) port – Current data rate of
the port (DDS operating rate minus IMC
rate).
H In-band Management Channel –
Configured data rate for the In-band
Management Channel.
ifAdminStatus
( ifEntry 7 ) Provides interface
status. Supported as
read-only. H up(1) – The interface is enabled.
H down(2) – The interface is disabled.