Paradyne 7612 SNMP DSU - Manual (Page 76)

Configuration Option Tables
A-12 7612-A2-GB20-10 November 1997
Table A-5. Terminal Port Options (3 of 3)
Inactivity Timeout
Possible Settings: Enable, Disable
Default Setting: Disable
Provides automatic logoff of an ATI session through the Terminal Port. When the
session is closed, User Interface Idle appears on the screen and the unit toggles the
Terminal port DSR lead.
Enable – The ATI session terminates automatically after the Disconnect Time set in the
next option. When the session was occurring over an external modem connected to the
Terminal port, the modem will interpret the DSR toggle as DTR being dropped and
disconnect.
Disable – An ATI session through the Terminal port will remain active indefinitely.
Disconnect Time(minutes)
Possible Settings: range 1 – 60
Default Setting: 5
Number of minutes of inactivity before the ATI session terminates automatically.
Timeout is based on no keyboard activity.
H Disconnect Time(minutes) option appears when Inactivity Timeout is enabled.
1 to 60 – The ATI user session is closed after the selected number of minutes.
Telnet Session Options
For Telnet Session Options, refer to Table A-6. To access the Telnet Session
Options screen, follow this menu selection sequence:
Main Menu
→
Configuration
→
Load Configuration From
→
Edit
→
Telnet Session
Table A-6. Telnet Session Options (1 of 2)
Telnet Session
Possible Settings: Enable, Disable
Default Setting: Disable
Specifies if the DSU will respond to a Telnet session request from a Telnet client on an
interconnected IP network.
Enable – Allows Telnet sessions between the unit and a Telnet client.
Disable – No Telnet sessions allowed.