Panasonic WJ-HD220 - Manual (Page 33)

33
● Simultaneous Recording & Playback
(SIMUL REC&PLAY)
This setting specifies whether to allow simultaneous play-
back and recording.
1. Move the cursor to SIMUL REC&PLAY with the [D] or
[C] button.
2. Select on or off with the JogDial, and press the JogDial.
The default is ON.
ON: Allows simultaneous recording and playback
including remote-access playback and FTP access.
The default recording rate is 15 FPS, and the high-
est rate is 30 FPS.
OFF: Places priority on recording triggered by pressing
the REC button or by an alarm input. Playback
including remote-access playback and FTP access
will be interrupted if recording starts. The default
recording rate is 15 FPS, and the highest rate is 30
FPS.
Notes:
• A 30 FPS recording rate will decrease to 15 FPS
when playback, remote-access playback, or FTP
access is carried out simultaneously with recording.
• Simultaneous playback will pause prior to a time
space depending on the recording rate when the
playback area on the disk nears the recording area.
This is to avoid the access collision caused by the
simultaneous recording and playback in an area on
the disk.
0.1 FPS: 20 minutes maximum
1 FPS: 2 minutes maximum
7.5 FPS: 15 seconds maximum
15 FPS: 7 seconds maximum
• Even if preset to 30 or 15 FPS, the actual recording
rate may drop to 7.5 FPS at worst while busy multi-
tasks such as playback, remote-access playback,
remote-access live image, FTP access, multi-split
display, or video motion detection are carried out
simultaneously. The status display will indicate
"*
→PLAY" while playing back the images recorded
with a rate different from the preset.
● Alteration Detection Setup
(ALTER DETECT)
You can enable or disable the recorder to add alteration-
detection signals in the JPEG data supplied to the network.
The default is OFF.
1. Move the cursor to ALTER DETECT.
2. Select ON or OFF with the JogDial and press the
JogDial.
ON: Detects alterations.
OFF: Does not detect.
Notes:
• When set to ON, the data transmission rate on the net-
work will slow down.
• Ask your dealer whether alterations are found in the
image data distributed via the network if necessary.
● Disk End Mode Setup
(DISK END MODE)
The menu offers the following options at the point where the
available recording space on the disk is used up: [STOP],
[CONTINUE]
1. Move the cursor to DISK END MODE with the [D] or
[C] button.
2. Select the desired mode with the JogDial, and press
the JogDial.
The default is CONTINUE.
STOP: Stops recording until a new mode other than
STOP is selected.
CONTINUE: Old data is automatically overwritten from
the disk start.
Note: Remaining capacity will be displayed on the monitor
by turning the JogDial counter-clockwise in recording
mode when STOP is selected.
DISK END DISK START
DISK END DISK START
DISK END DISK START
DISK END DISK START
Waiting for a new entry
Overwritten automatically
Stop
REC
Restart
REC
[STOP]
[Default]
[CONTINUE]
SYSTEM SETUP (1 OF 2)
PASSWORD LOCK OFF
ALL
→ *****
OPERATION
→ *****
KEYLOCK BUZZ OFF
SKIP ALM-RECALL 1PAGE
SIMUL REC&PLAY ON
ALTER DETECT OFF
DISK END MODE CONTINUE
DISK END BUZZ ON