Panasonic WJ-HD220 - Manual (Page 48)

48
● Monitor Display
There are two monitoring modes, alarm associated (SPOT)
mode and alarm ignore (OFF) mode, depending on the
selection for MONITOR MODE in the ALARM SETUP menu.
Typical cases are described below for each setup.
Alarm Associated Mode
• The image of the alarmed input is displayed on the mul-
tiscreen monitor in single spot mode, interrupting what-
ever live, playback, single or multiple image previously
displayed. When a new alarm is received, the last acti-
vated input image will be displayed.
• The blinking camera title and "ALARM" indication on the
monitor will be alternately. For example, when an alarm
is received from CH1, "CH1 ALARM" will be displayed
on the monitor.
• Combination cameras connected to VIDEO IN 1-4 can
be aimed at the preset position if is specified for PRE-
SET in the TRIGGER ACTION SETUP of the REC SETUP
menu.
• When a camera signal loss has occurred, the monitor
display switches to a blackout screen with the channel
number indicated, for example, "CH 1 LOSS".
Alarm Ignore Mode
• The images being displayed will remain on the monitor
screen when an alarm arises, but the "ALARM" status
indication will appear.
The following outputs for each channel will be enabled or
disabled depending on the settings made in the TRIGGER
ACTION SETUP menu.
• The following will be disabled when OFF is selected for
the channel.
• The following will be enabled when REC&ALM is select-
ed for the channel.
• Only alarm recording will be enabled when REC is
selected for the channel.
● Alarm Recording
The recorder starts alarm recording with the preset rate and
picture quality, if applicable. See ALARM RECORDING for
details.
CAM1 CH1ALARM
CAM1 CH1LOSS
● Alarm Buzzer
The buzzer sounds when an alarm is input, if applicable.
● Alarm Log Recall and Search
The alarm events are stored in the log for later reference.
● Alarm Status Output
The active status and recovery status are output to the
external devices via the terminals on the rear panel.
● Alarm Notice Mail
When connected to the Ethernet, the recorder sends an e-
mail to notify the preset URL that the alarm is activated.
● Resetting Alarm
See below.
● Suspending Alarm
See below.
■ Resetting Alarm
The activated alarm is reset by any of the inputs: manual
(all) reset, auto reset, external reset, or pressing the [REC
STOP] button.
Resetting changes the status of the recorder as follows.
• The recorder stops alarm recording.
• The buzzer, if activated, stops beeping.
• The recorder outputs an alarm recovery signal from the
rear panel.
• The Alarm Out signal on the rear panel is reset.
● Manual (All) Reset
Pressing the [RESET] button on the front panel will clear all
operating alarms, and allow the blinking or lit ALARM indi-
cator to go off.
ALARM
SUSPEND
RESET