Panasonic WJ-HD220 - Manual (Page 97)

97
8 Formatting HDD (HDD FORMAT)
This command initializes the HDD format and is applic-
able to HDDs of *, ERR, or ADD status.
Caution: Formatting is an irreversible procedure. We
strongly recommend that, before formatting, you
either save the recorded data into the server via the
network, or you save the data on VCR tapes via the
REC OUT terminal.
1. Display the DISK MENU window.
2. Move the cursor to HDD FORMAT, and press the
JogDial.
The password prompt appears.
3. Enter the ALL password using the CAM SELECT but-
tons 1 through 8. The default password is 12345.
Access to the HDD will be possible if the correct pass-
word is entered.
4. Rotate the JogDial to select the HDD you wish to for-
mat, and press the JogDial.
1: Formats HDD #1.
2: Formats HDD #2.
ALL: Formats HDD #1 and #2.
The window prompts you to confirm whether the HDD is
to be formatted or not.
8 Removing Logical Link (REMOVE LINK)
This command logically disconnects the faulty HDD
from the recorder and is applicable to an HDD of *,
ERR, or LOST status.
You may use this command before physically removing
the faulty HDD, or when you continue to operate the
system after logically removing the faulty HDD.
1. Display the DISK MENU window.
2. Move the cursor to REMOVE LINK.
3. Select YES with the JogDial, and press the JogDial.
YES: Logically removes the faulty HDD.
When YES is selected, the display YES will turn to SET
DONE for 5 seconds, and the window will return to nor-
mal operation.
When the [STOP] button is pressed, the window returns
to that of step 1.
Select RESTART to return to normal operation.
Note: The window of step 1 appears following the
"ERROR" message when this command is used
under the conditions below:
A single HDD or no HDD exists.
Both HDDs malfunction.
DISK MENU
NO.1:XXX.XXGB
NO.2:XXX.XXGB
REMOVE LINK SET →
HDD FORMAT SET
→
RESTART SET
→
REMOVE LINK YES
→
REMOVE LINK SET DONE!
DISK MENU
NO.1:XXX.XXGB
NO.2:XXX.XXGB
REMOVE LINK SET
→
HDD FORMAT SET →
RESTART SET
→
PASSWORD
PASSWORD *****