Philips WV-NM100 - Manual (Page 16)

16
SETUP
Setup with the Provided "Panasonic IP Setup" Software
Set up the network of the camera by using the "Panasonic IP Setup" software included on the CD-ROM provided
with the camera.
The "Panasonic IP Setup" starts up.
The MAC address and the IP address of the connected camera
will be displayed. (Click the [REFRESH] button if they are not dis-
played.)
Screenshot 1
Click the MAC address/IP address of the cam-
era to be set up.
Click the [NETWORK SETUP] button.
• When two or more cameras are connected,
the MAC addresses and the IP addresses of
all the connected cameras will be displayed.
• The "Panasonic IP Setup" software can rec-
ognize only those cameras in the same sub-
net.
• The updated MAC addresses and IP
addresses of all the connected cameras that
are in the same subnet will be displayed by
pressing the [REFRESH] button.
Notes
STEP3
STEP2
When the provided CD-ROM is inserted into the CD-ROM drive of the PC, the launcher software starts up and the
readme file is displayed.
Items included in the software
• SETUP
• Instructions
• MPEG-4 Installation
After reading the readme file, click the [SETUP] button.
• Double click "launch.exe" on the provided CD-ROM if the launcher software does not start up automatically.
• If a firewall (including software) exists, allow access to all UDP ports. Otherwise, it is impossible to use the
"Panasonic IP Setup" software.
Notes
STEP1