Philips WV-NM100 - Manual (Page 28)

28
SETUP
Network speed Common to all connection Set the network speed.
types
Use the default setting "auto" for the network speed.
Selectable parameters: auto (default setting), 100 Mbps (full duplex),
100 Mbps (half duplex), 10 Mbps (full duplex), 10 Mbps (half duplex)
HTTP port Connection type 1, 2 and 3 Use the default setting "80" for the HTTP port.
Connection type 4 If multiple cameras are connected, it is required to set up each cam-
era individually.
However, the port numbers already assigned to other hardware are
not available. The following port numbers are also not available
because this camera already uses them.
Port number: 20, 21, 23, 25, 42, 67, 68, 69, 105, 110, 123, 161, 162,
546, 547, 5002
Host name Connection type 1 No setting required
Connection type 2 Refer to your network administrator and set the designated host
name if required.
Connection type 3 and 4 Refer to your Internet service provider and set the designated host
name if required.
BOOTP Connection type 1 and 2 Set to ON when using the "Panasonic IP Setup" software.
Connection type 3 and 4 No setting required
DHCP Connection type 1 Set to OFF.
Connection type 2 Set to ON if the intranet uses the DHCP.
Connection type 3 Set to OFF.
Connection type 4 Set to ON if the broadband router uses the DHCP.
DNS Connection type 1 Set to OFF.
Connection type 2, 3 and 4 Set to ON when using the DNS.
Primary server Connection type 1 No setting required
Secondary server Connection type 2, 3 and 4 Set the IP address of the DNS server when using the DNS.
Refer to your Internet service provider for the IP address of the DNS
server. Primary and secondary IP addresses can be set for the
DNS.