Philips WV-NM100 - Manual (Page 33)

33
Begin the operation from the "Basic setup" page.
The "Control" page appears and the still picture of the cam-
era is displayed. Operation buttons are displayed below the
still picture.
Screenshot 2
Screenshot 1
How to operate
If the preparations have been completed, you can begin the operation from the "Basic setup" page.
Click the "Control" button.
STEP1
Operate the camera and adjust the picture.
Panning and tilting
Click the arrow buttons (up / down / right / left) to
adjust the horizontal and vertical position.
The center of the box surrounded by the arrow
buttons (the point where the horizontal line and
the vertical line cross) is the current position of
the camera.
If you click inside the box surrounded by the
arrow buttons, you can pan and tilt the camera
wider than by clicking the arrow buttons.
Image capture size
Click one of the picture resolution buttons (VGA
(640 x 480) / QVGA (320 x 240) / QQVGA (160
x 120)) to display the picture with the desired
resolution.
Adjustment of the brightness of the picture
Click the buttons to adjust the brightness of the
picture. The left end button (–) is the darkest
and the right end button (+) is the brightest. The
green button is the currently selected level.
Image size
Click one of the buttons (x1.0 / x1.5 / x2.0) to
select the desired image size.
When the picture is magnified, the quality of the
picture may be decreased.
AUX
Click one of the buttons (High/Low) to set the
status of the AUX output connector. (Refer to p.
53 for details.)
One time pan
You can monitor the picture by panning the
camera one time to the left and right.
STEP2
• If the preparations have been completed, start up the
browser and display the "Top Menu" page of the desired
camera. The camera picture appears on the "Top Menu"
page.
• Several pictures shot during the panning/tilting may not
be displayed when "Refresh interval" is set to "Very
Slow".
Note