Philips WV-NM100 - Manual (Page 24)

24
SETUP
Network Setup of the Camera
After completing the network setup of the PC, begin the network setup of the camera.
If multiple cameras are connected, it is required to set up each camera individually.
The following information is necessary for the network setup of the cameras.
If you do not have the following information, refer to your network administrator or your Internet service provider.
For further information about the terms, refer to page 74-75.
• IP address
• Subnet mask
• Port number
• Default gateway (when using a gateway server or a router)
• Primary and secondary DNS server address (when using DNS)
Begin the setup when the PC is in the same condition as just
after the startup.
The browser starts up. The web page set as the home page in
your browser appears.
(The picture is the page of the Panasonic web site.)
Screenshot 2
Screenshot 1
Start up Internet Explorer on your PC.
STEP1
Enter the IP address assigned by the
"Panasonic IP Setup" software in the "Address"
box of Internet Explorer. (If the IP address has
not been assigned yet, enter the default IP
address "192.168.0.10".)
You can confirm the assigned IP address by
pressing the [REFRESH] button in the
"Panasonic IP Setup" window.
If the broadband router is set to use the address
translation, enter [IP address + : (colon) + port
number] in the "Address" box, and press the
enter key.
STEP2