Philips WV-NM100 - Manual (Page 26)

26
SETUP
The "Network" page appears.
Screenshot 6
Set parameters for each item in the "Network"
page.
The parameters differ depending on the connec-
tion type (refer to pages 12-14).
For further information, refer to the next page.
Click the [SET] button after completing the
setup.
After you click the [SET] button, the
"Command Executing" message appears.
(This message will appear even when you
click the [SET] button in other windows.) Avoid
doing any operation while the message is dis-
played.
! Important
STEP7
STEP6
• About the address translation function (Static IP masquerade, Network Address Translation (NAT))
The address translation function changes a global IP address to a private IP address, and "Static IP masquer-
ade" and "Network Address Translation (NAT)" have this function. This function is to be set in a router.
To browse camera pictures via the Internet by connecting the camera to a broadband router, it is necessary to
assign a respective port number for each camera and address translation by using the address translation func-
tion. For further information, refer to the operating instructions of the broadband router.
Note
Enter [Global IP address + : (colon) + port number]
in the "Address" box of the browser via the Internet.
vvv.xxx.yyy.zzz:82
vvv.xxx.yyy.zzz:81
Global address
for the WAN
vvv.xxx.yyy.zzz Private address
for the LAN
192.168.0.254
Private address
192.168.0.2
Port number: 82
Private address
192.168.0.1
Port number: 81
Address translation
vvv.xxx.yyy.zzz:82
→
192.168.0.2:82
Address translation
vvv.xxx.yyy.zzz:81
→ 192.168.0.1:81
Broadband router
Internet
(WAN)
Cable modem or
xDSL modem