Philips WV-NM100 - Manual (Page 53)

53
OTHER FUNCTIONS
Alarm Connector and AUX Output Connector
Security door
sensor
Alarm input connector
Ground terminal
Alar
m input
Alarm output connector
AUX output connector
(To control external devices:
for example, lighting ON and OFF)
Customizing the Contents of the Alarm Mail
You can customize the contents of the alarm mail notifying that an alarm has occurred and the alarm date and time.
To customize them, do the following:
Create the contents of the alarm mail with a text editor and save the file as "almmail.tmpl".
Start up the FTP software and connect to the camera by entering the IP address of the camera.
The destination where to transfer the file is "/flash". To login to the camera, enter "admin" for the user
name and the password registered for the user name "admin" if the password has been changed (the
default password is "password").
Upload the new file (almmail.tmpl) in text format to the camera.
STEP3
STEP2
STEP1
You can set the type of the device connected to
the AUX output connector.
The settings can be made on the "AUX output"
page of "Alarm&Transmission".
Click the [Alarm&Transmission] button, and then
click the [AUX output] tab.
The "AUX output" page of "Alarm&Trans-
mission" appears and you can check the current
setting of the "AUX setup".
Click the [SET] button after selecting "High" or
"Low", according to the specifications of the
external device to be connected, to enable the
setting.
You can set the alarm operation when an exter-
nal device such as a sensor is connected to the
alarm connector inside the cord cover of the
camera.
You can set functions such as sending e-mails
or transferring pictures to the server when an
alarm signal is input by a sensor, as explained in
"Settings of the Actions to be Performed when
Motion is Detected" on page 43.
Do not connect an external device if it is
beyond the specified ratings of the camera
(refer to page 68).
! Important