Philips WV-NM100 - Manual (Page 55)

55
Setting items
• If the setting item is overlapped between "Basic setup" and "Advanced setup", the latest setting has priority.
For example, if a different setting is made on the "Operation mode" page after the same item has been set on the
"Basic setup" page, the setting made on the "Operation mode" page is valid.
• You may have problems browsing still/motion pictures depending on the bandwidth of the network to which the
camera is connected. In this case, perform the setting of "Bandwidth control" on the "Operation mode" page of
"Advanced setup".
• Depending on the traffic of the network, there might be difficulties displaying the picture. In this case, select Slow
or Very Slow for "Refresh interval" of "JPEG mode setup".
! Important
(When "MPEG-4" is selected)
"MPEG-4 mode setup"
If "MPEG-4" is selected, the setting of the following
items is required.
"Image capture size"
Select an image capture size from the following:
CIF (352 x 288) / QCIF (176 x 144)
"Quality of image"
Select a quality of the image from the following.
Fine / Normal / Low
"Max bitrate (per 1 client)"
Select an M-PEG bit rate for each client.
32/64/128/256/512/1024/Unlimited (kbps)
"Refresh cycle"
In a network environment with frequent errors, by
setting the refresh cycle shorter, you can decrease
the cause of interference on the monitor screen.
However, the loading speed may become slower.
Enter a number between 1 and 30 (sec).
"UDP port"
Enter the transmission port number of the camera.
"Transmission type"
Select "Unicast" or "Multicast" for the transmission
setting.
"Unicast":
Up to four users can connect to a sin-
gle camera to monitor the picture.
"Multicast": Maximum number of users connected
in a subnet can connect to a single
camera to monitor the picture.
"Multicast address"
Set the multicast IP address for transmission.
"Multicast port"
Set the multicast port number (number of the port
that the camera uses to transmit the picture) for
transmission.
"Operation mode selection"
Select "JPEG" (still picture) or "MPEG-4" (motion pic-
ture). The parameters for JPEG/MPEG-4 setting auto-
matically appear.
"Bandwidth control"
Select a bandwidth control from the following:
32 / 64 / 128 / 256 / 512 / 1024 / Unlimited (kbps)
"JPEG mode setup"
If "JPEG" is selected, the setting of the following items
is required.
"Refresh interval"
Select a refresh interval from the following:
Fast / Middle / Slow / Very Slow
"Image capture size"
Select an image capture size from the following:
VGA (640 x 480) / QVGA (320 x 240) / QQVGA
(160 x 120)
"Quality of image"
Select a quality of the image from the following.
Super Fine / Fine / Normal / Low