Panasonic SX-KN7000 - Manual (Page 114)

Part Setting
You can make detailed settings for each part.
1. On the REALTIME RECORDING display,
press the PART SETTING button.
• The settings comprise two pages of the dis-
play. Use the PAGE buttons to switch pages.
2. Use the PART
∧
and
∨
buttons to select a
part.
3. Use the
∧
and
∨
buttons to set the correspond-
ing item.
<PAGE 1>
PITCH POINT:
The pitch at which the pattern progression
sound is lowered by one octave.
• When the root note of the specified chord is
higher than the set pitch point, the pitch of that
part is automatically lowered by one octave,
thus avoiding an unnaturally high accompani-
ment pitch.
• This is effective only for the part for which the
Melody group was selected in CHORD MOD-
IFY CHANGE.
SOUND:
Use the panel buttons to select the sound.
DIGI EFF:
Set the DIGITAL EFFECT to on or off.
• (SOUND) is the initialized setting of the sound.
BALANCE:
Adjust the volume balance.
PAN:
Adjust the stereo balance of each part (LEFT
64 – CENTER – RIGHT 63).
• At “LEFT 64”, the sound is all the way to the
left, at “RIGHT 63” all the way to the right. The
center point is CENTER.
BEND RANGE:
Adjust the range of pitch change when the
PITCH BEND wheel is operated (0 to 12).
<PAGE 2>
EQ-Hi:
Sound correction in the high range.
• Use the FC ∧
and
∨
buttons to adjust the
standard frequency. Use the GAIN
∧
and
∨
buttons to set the ratio of change.
EQ-Low:
Sound correction in the low range.
• Use the FC ∧
and
∨
buttons to adjust the
standard frequency. Use the GAIN
∧
and
∨
buttons to set the ratio of change.
DSP1:
TOTAL MODE: Depth of DSP1 (0 to 127).
SOUND MODE: DSP 1 on/off (– – ) setting
DSP2:
DSP2 on/off (– – ) setting.
REV:
Depth of the REVERB (0 to 127).
CHO:
Depth of the CHORUS (0 to 127).
Co
m
p
o
s
e
r
Part V Composer
114
QQTG0671