Panasonic SX-KN7000 - Manual (Page 161)

Separate Setting
You can output a desired part or parts through the two SUB OUT terminals.
1. On the SOUND MENU display, select SEPA-
RATE SETTING.
• The display looks similar to the following.
2. Use the MODE button to select desired output
mode.
OFF:
The SUB OUT terminals are not used.
STEREO:
The SUB OUT terminals are used as a two-
channel stereo output device.
MONO x 2:
The SUB OUT terminals are used as two
monaural output devices.
3. Use the PART ASSIGN button to select the
part or parts for output.
• The parts can be selected differ depending on
the modes (STEREO/MONOx2).
• If you select the MONOx2 mode, the same
part can not be selected for both SUB OUT 1
and 2.
4. Use the “With MAIN OUT” button to specify
whether the MAIN OUT terminal is also used
for output (OFF/ON).
5. Use the EXPRESSION button to specify
whether the EXPRESSION effect is effective
for output (OFF/ON).
• For a detailed explanation of the SUB OUT
terminals, refer to page 200.
APC Reverb Setting
Although an appropriate REVERB is applied for the automatic accompaniment parts depending on the
rhythms by default, you can adjust the REVERB level for each part.
1. On the SOUND MENU display, select APC
REVERB SETTING.
• The display looks similar to the following.
2. Use the PART
▲ and ▼ buttons to select the
part, the DEPTH
∧
and
∨
buttons to set the
value (PRESET IN RHYTHM, 0 – 127).
• PRESET IN RHYTHM is an optimal preset
value for each rhythm for use with the APC
Reverb Setting.
So
u
n
d
Part VIII Sound
161
QQTG0671