Panasonic SX-KN7000 - Manual (Page 191)

Control Messages
Enable or disable the exchange of various control data.
1. On the MIDI MENU display, select CONTROL
MESSAGES.
• The display looks similar to the following.
• The CONTROL MESSAGES display consists
of 3 pages. Use the PAGE buttons to switch
between pages.
2. Use the MESSAGE
▲ and ▼ buttons to select
the control message.
3. Use the ON and OFF
∧
and
∨
buttons to
specify on or off for the control message.
ON:
Data for the control operation is exchanged.
OFF:
Data for the control operation is not ex-
changed.
• The BANK SELECT setting is effective only
when PRG. CHANGE is set to ON.
• The EFFECT & REVERB setting controls the
DIGITAL EFFECT, SOUND DSP, CHORUS,
MULTI and REVERB on/off.
• RPN is the general term for KEY SHIFT,
TUNING, PITCH BEND RANGE and MODU-
LATION SENSITIVITY.
4. Repeat steps 1 and 2 for each control as
desired.
Realtime Messages
Enable or disable the exchange of START/STOP data (REALTIME COMMANDS), and select the CLOCK
mode.
1. On the MIDI MENU display, select REALTIME
MESSAGES.
• The display looks similar to the following.
2. Use the buttons on the left side of the display
to select a function.
3. Use the VALUE
∧
and
∨
buttons to change
the setting.
REALTIME COMMANDS
ON:
Rhythm and SEQUENCER start/ stop, con-
tinue, and song position pointer data can
be transmitted/received.
OFF:
This data cannot be transmitted/received.
CLOCK
INTERNAL:
This instrument’s internal clock is used to
control the performance. The clock of the
connected equipment is disabled.
MIDI:
The clock of the connected equipment is
used to control the performance. This in-
strument’s clock is disabled. (The tempo is
displayed as “ = – – – .”)
• The CLOCK is set to INTERNAL when the
power to this instrument is turned on.
4. Repeat steps 2 and 3 for the other function if
desired.
MID
I
Part XIII MIDI
191
QQTG0671