Panasonic SX-KN7000 - Manual (Page 83)

Sequencer Play
Play back your recorded performance.
1. Press the SEQUENCER PLAY button to turn
it on.
• The display looks similar to the following.
2. Use the SONG
∧
and
∨
button to select the
song number you wish to play back.
3. Use the balance buttons below the display to
show “PLAY” above the track numbers you
wish to have played back.
• Highlighted track numbers indicate tracks that
are already recorded. Only highlighted track
numbers can be selected for playback.
• You can select two or more tracks to play back
at one time.
4. Press the SEQUENCER RESET (FILL IN 1)
button.
• The SEQUENCER returns to the beginning of
the song and the beginning panel settings are
recalled.
5. To begin playback from a measure other than
measure 1, use the MEAS
∧
and
∨
buttons to
specify the beginning measure.
• “MEASURE=” indicates the current measure
number.
6. Press the START/STOP button.
• The recorded performance is played back from
the specified measure.
• When playback is begun from a measure in
which an INTRO, COUNT INTRO, FILL IN or
ENDING is recorded, the corresponding func-
tion does not work.
• You can press the MIXER button and modify
the settings for each part.
• For information about LYRICS, refer to page
128.
7. To stop playback, press the START/STOP but-
ton.
• If the START/STOP button is pressed again,
playback will continue from the point it was
interrupted.
8. When you are finished playing back your per-
formance, press the SEQUENCER PLAY but-
ton to turn it off.
SEQUENCER
PLAY EASY REC
If a rhythm progression has been recorded in
the RHYTHM (RHY) part, the MEASURE dis-
play used in the STEP RECORD and EDIT dis-
plays conforms to the time signature data
stored in the RHYTHM part.
Adjusting the playback tempo
Even with a song having recorded tempo data, you can use TEMPO/PROGRAM or TAP TEMPO to
adjust the tempo to your liking.
• When the tempo is changed, all the tempo data of that song is automatically changed by the same
ratio. Accordingly, even in song data in which tempo change data is stored, a single adjustment
of the tempo produces a natural-sounding playback.
• To return to the original tempo, while the song is stopped press the SEQUENCER RESET button.
Note that the tempo change is also canceled when you switch to another song or load a new song.
• The adjusted tempo is canceled when you begin the recording procedure and the original tempo
data will be recorded.
Se
q
u
e
n
c
e
r
Part IV Sequencer
83
QQTG0671