Panasonic SX-KN7000 - Manual (Page 72)

Record a phrase
“User Bank” A, B and C are reserved for storing your original phrases.
• You can also copy phrases which are recorded in the SEQUENCER.
1. Press the PROGRAM MENUS button to turn
it on.
• The display looks similar to the following.
2. Select PERFORMANCE PADS.
• The display looks similar to the following.
3. Use the buttons to the left of the display to
select a RECORDING BANK.
• The display changes to the RECORD PAD
display.
• You can press the BANK NAMING button and
assign a name to the bank.
• If the BANK CLR button is pressed, all the
data in the bank is cleared (a confirmation
display appears).
4. Use the buttons below the display to select
the pad number to record.
• The display changes to the PAD RECORDING
display.
• You can press the PAD NAMING button and
assign a name to the bank.
• To clear all the current data in the selected
pad, press the CLEAR THE PAD button, and
then press the YES button on the confirmation
display.
5. Use the MEASURE
∧
and
∨
buttons specify
the number of measures in the phrase. Use
the TIME SIGNATURE
∧
and
∨
buttons to
specify the time signature of the phrase.
6. Press the OK button.
• For details about KEY SETTING, refer to page
111.
• For details about CHORD MODIFY CHANGE,
refer to page 113.
7. Select the part to record to.
• Press the button for PART 1 or PART 2.
• Two parts can be recorded (PAD 1– 4).
• The display looks similar to the following.
8. Proceed to record.
• The recording procedure is the same as for
the COMPOSER. (Refer to page 112.)
• There is no DSP SET.
• In the PLAY SETTING, if LOOP is set to OFF,
LOOP recording is not possible.
Pe
rf
o
rm
a
n
c
e
Pa
d
s
Part III Performance Pads
72
QQTG0671