Panasonic SX-KN7000 - Manual (Page 140)

Loading data
Load the data from the SD card to this instrument’s memories.
• Note that the load procedure causes any data which is currently stored in the relevant memories to
be erased.
SD LOAD
Load data that saved to a card into this instru-
ment’s memory.
1. Insert the SD card with the stored data into
the SD slot. (See page 138.)
• Close the lid securely.
2. Press the SD button to turn it on.
3. On the SD MENU display, select LOAD.
• The display looks similar to the following.
• If there are only SMF files on the card, the
display automatically changes to the SD-
SOUND (SMF) LOAD display.
4. Use the buttons to the right of the display to
select the type of loading.
FOLDER:
Select files to load from a list of all folders and
of saved songs in each folder.
ALPHABET (See page 141.)
Select files to load from an alphabetical list of
all songs.
NUMBER (See page 141.)
Select files to load specifying folder and song
numbers.
• The priority that sets which display is shown
first can be set at the SD PREFERENCES
display. (Refer to page 152.)
FOLDER
1. Use the buttons below the display to select
the SONG you wish to load.
• Select the folder name first, and then select
the SONG name.
2. Press the LOAD button.
• The LOAD operation begins.
• When the operation has been successfully
completed, “COMPLETED!” is shown on the
display.
• If song data was loaded, you can press the
START/STOP button to begin playback when
the SEQUENCER PLAY display is active.
• You can load the type of data for which only
one song can be recorded in the
SEQUENCER. (This type is available for cards
used with older Technics models.) Note, how-
ever, that in this case, the song is loaded into
SONG 1, but the data in SONG memories 2
to 10 are erased.
• It is not possible to load RHYTHM CUSTOM
data that was created on older models.
• You can also access the LOAD display by
pressing the SD button for a few seconds.
SD
LOAD
SD
c
a
rd
Part VII SD card
140
QQTG0671