National Instruments 800 Series - Manual (Page 100)

© National Instruments Corporation Index-1 VXIpc 800 Series User Manual
Index
A
ACCESS LED, 1-7, C-3
address map, I/O (table), B-3 to B-4
application-specific interface chips, custom, 1-5
audio capability. See speaker.
B
BIOS. See also CMOS.
clearing CMOS contents, 3-12
entering setup, 4-1
viewing settings, F-4
board access LEDs, C-3
bulletin board support, G-1
C
CLK10 signal, VXIbus
accuracy, F-1
definition, F-1
routing, 3-5 to 3-7
selecting signal source (figure), 3-6
SMB CLK10 direction (figure), 3-6
SMB CLK10 polarity (figure), 3-7
SMB CLK10 termination (figure), 3-7
CMOS. See also BIOS.
PC configuration, 3-12
setting back to default, F-4
COM1 and COM2 connectors and signals,
D-6 to D-7
common questions about VXIpc 800 Series,
F-1 to F-4
configuration
default settings, 3-1 to 3-3
factory default settings (table), 3-3
parts locator diagram, 3-2
EEPROM, 3-8 to 3-10
configuration settings (figure), 3-9
fixing invalid configuration,
3-9 to 3-10
power-on self configuration status
(figure), 3-8
protecting against electrical hazards
(warning), 3-10
electrostatic discharge (warning), 3-1
installed system RAM, 3-10
installing VXIpc-800 Series, 3-13 to 3-14
PC configuration, 3-10 to 3-13
Ethernet power-on defaults, 3-13
GPIB interrupt level, 3-11
parallel port DMA level, 3-12
SCSI termination, 3-11
system CMOS, 3-12
removing metal enclosure, 3-4
trigger input termination, 3-8
VXIbus CLK10 routing, 3-5 to 3-7
VXIbus Slot 0/non-Slot 0, 3-4 to 3-5
connectors
COM1 and COM2, D-6 to D-7
Ethernet, D-5 to D-6
external SMBs, D-14
front panel connectors, 1-6
front panel connectors (table), D-1E-1
GPIB (IEEE-488.2), D-12 to D-13
keyboard and mouse, D-3
parallel port, D-8 to D-9